10 thoughts on “ExOne Sand Printing Process

  • June 26, 2019 at 11:18 am
    Permalink

    bin hier wegen GdFT am KIT 😛

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    Love the process video, but the breakout however shows a failed casting above the logo where the mold was incompletely filled! Also, lots of flashing at parting lines, which you did not show cleaning up!

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    what does a company charge to make a sand mold from a solidworks model?

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    I wonder what kind of sand and activator is used and what kind of quick drying resin is or can be used on a  home project.. I have the system projected and partialy built , from the heads to deposit the resin, the dumpster to lay down the sand layers up to all the mechanical structural parts and electronics/software..  If anyone can help me with this information I will receive it gladly since I have not much experience with chemistry … Thank You

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    Love it. Is this North Huntington?

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    I was wondering the same thing. this cant be like good ol' green sand. i figure once the resin is set it has to be bonded hard as a rock.

    On a side note that guys should really be wearing a mask, even though he is at a down draft table.

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    What a great video – this is how to do a technology demonstration folks.

    Reply
  • June 26, 2019 at 11:18 am
    Permalink

    Fantastic video! 🙂 And a great channel too.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *